HOTBIRD SATELLITE 2026: LATEST AUTOMATIC CHANNEL SCAN FREQUENCY & SETUP GUIDE
As one of the most prominent satellite positions in the world, the Hotbird 13° East orbital slot hosts hundreds of free-to-air (FTA) channels and premium digital platforms. With the recent full deployment of the Hotbird 13F and Hotbird 13G satellites, signal stability has reached new heights. However, many users still ask, “Why is my channel list missing stations?” or “How do I find new frequencies?”
In this guide, we break down the technical jargon to provide a step-by-step walkthrough for setting up Hotbird and using the Network Information Table (NIT) feature to download all current frequencies in one go.
Step 1: Hardware and Physical Connection Check
Before diving into the software settings, ensure the signal is physically reaching your receiver or TV.
- LNB Connection: Ensure the coaxial cable coming from the satellite dish is securely screwed into the LNB IN (or Satellite) port on the back of your receiver/TV.
- LNB Type: For Hotbird, a standard Universal LNB is required. In your device settings, the LNB frequency must be set to 9750/10600 MHz.
- DiSEqC Switch Settings: If you are using a multi-dish setup (e.g., both Turksat and Hotbird), Hotbird is typically assigned to DiSEqC 2 or Port B. If you have a single dish dedicated to Hotbird, set this to “Off” or “1”.
Step 2: Software Configuration and Auto-Scan Frequency
There are over a thousand channels on Hotbird. Instead of entering them one by one, we use “Master Frequencies” that trigger the device’s “Network Search” feature.
Hotbird Latest Automatic Scan Parameters:
Enter any of the following values into your “Manual Scan” or “Add Transponder” menu to update the entire satellite:
| Parameter | Primary Frequency (Recommended) | Alternative Frequency |
| Frequency | 10775 MHz | 11219 MHz |
| Polarization | Horizontal (H) | Horizontal (H) |
| Symbol Rate | 29900 | 29900 |
| FEC | 5/6 (or Auto) | 5/6 |
| Network Search (NIT) | ON (Enabled) | ON (Enabled) |
Step-by-Step Installation:
- Press the Menu button on your remote and navigate to Installation or Channel Setup.
- Select Hotbird 13.0E from the satellite list.
- Go to the Transponder (TP) List and add the 10775 H 29900 values.
- Crucial Step: Before starting the scan, ensure the “Network Search” (NIT) option is toggled to “ON”. This tells your receiver to look for new frequencies listed in the satellite’s internal data stream.
Step 3: Post-Installation Performance Tips
The scanning process usually takes 10-15 minutes. Once finished, new channels will appear at the end of your channel list.
- “No Signal” Error: If the signal quality bars remain at 0% after entering the frequency, check your DiSEqC settings (LNB 1, 2, 3, 4) to ensure the receiver is looking at the correct port.
- Missing Channels: If some channels are still missing after the scan, try a secondary scan using 12692 H 27500 (a secondary master frequency for the Bis TV package) to further populate your list.
Hotbird automatic scan frequency, 2026 satellite frequencies, Hotbird 13E channel setup, Hotbird network search frequency, Hotbird 13G installation, satellite receiver channel update, LNB settings, Hotbird 10775 H 29900, FTA Hotbird channels, satellite technical support, Lyngsat Hotbird 2026, KingOfSat frequency list, Eutelsat setup guide.